對于壓縮空氣壓力方面一般要為3-8bar(0.3-0.8MPa)，當然不是這個壓力范圍內，同一臺增壓泵的增壓效果一樣的，同一臺氣動增壓泵的增壓比（驅動活塞與增壓活塞的面積比）是固定的，當然，驅動氣壓3bar時與驅動氣壓8bar時的zui大輸出壓力是不一致的。
For compressed air pressure, it is generally 3-8 bar (0.3-0.8 MPa), but it is not within this pressure range. The boosting effect of the same booster pump is the same, and the boosting ratio of the same pneumatic booster pump (the area ratio of the driving piston to the boosting piston) is fixed. Of course, the driving pressure of 3 bar is different from the high output pressure of 8 bar.
因此，不要誤解為驅動氣壓要求為3-8bar是指這個壓力區間內都能達到同一個壓力，氣動增壓泵的輸出壓力是與驅動氣和預增氣的壓力息息相關的（驅動氣體zui低壓*增壓倍數=輸出壓力），所以，設備選型時要根據現場的壓縮空氣的壓力選擇合適的增壓比，正常情況下，所選設備的輸出壓力要比實際使用壓力大一些，留有一定的余量。因為當壓力越接近氣體增壓泵的zui大輸出壓力時，增壓泵頻率越慢，流量越小，達到zui大輸出壓力相對困難。提高壓力比，就可以很好地解決這種問題。
Therefore, do not misunderstand it as the requirement for a driving air pressure of 3-8 bar means that the same pressure can be reached within this pressure range. The output pressure of the pneumatic booster pump is closely related to the pressure of the driving gas and pre added gas (driving gas: low pressure * boost ratio=output pressure). Therefore, when selecting equipment, it is necessary to choose the appropriate boost ratio based on the on-site compressed air pressure. Under normal circumstances, The output pressure of the selected equipment is slightly higher than the actual usage pressure, leaving a certain margin. Because as the pressure approaches the high output pressure of the gas booster pump, the frequency of the booster pump slows down and the flow rate decreases, making it relatively difficult to reach the high output pressure. Increasing the pressure ratio can effectively solve this problem.
耗氣量的要求，一般要求流量≥0.6m?/min左右，耗氣量不是一個固定值，當氣體增壓泵的負載越小時，增壓泵的頻率越快，負載越大時，氣體增壓泵的頻率越慢，當達到大輸出壓力時，氣體增壓泵停止工作，不在耗氣?？諝鈮嚎s機的選擇上，7.5kW的空壓機配套200L以上的氣罐，是讓氣體增壓設備正常工作的z低要求。
The requirement for gas consumption generally requires a flow rate of ≥ 0.6m/ Around min, the gas consumption is not a fixed value. When the load of the gas booster pump is smaller, the frequency of the booster pump is faster. When the load is larger, the frequency of the gas booster pump is slower. When the output pressure is high, the gas booster pump stops working and no longer consumes gas. In terms of the selection of air compressors, the 7.5kW air compressor is equipped with a 200L or more air tank, which is a low requirement for the normal operation of gas boosting equipment.
感謝您的閱讀，此文的文章來源：
氣體增壓泵更多的內容和問題請點擊：
http://www.allarabandroid.com我們會繼續努力的為您提供服務，感謝您的支持！
Thank you for reading. The source of this article is: Gas Booster Pump. For more information and questions, please click on:
http://www.allarabandroid.com We will continue to work hard to provide you with services. Thank you for your support!
