The gas-liquid booster pump will always be stored for one day. At this time, corresponding preventive and safety measures should be taken. Do not place it for a short time or a long time to cause equipment failure. Let's talk about storage requirements.
Before storage, check whether each gas-liquid booster pump is damaged. In case of damage during transportation, the extent of damage shall be strictly evaluated, recorded and immediately notified to the supplier in writing (to obtain relevant storage suggestions).
Before storage, unpacking acceptance shall be carried out - carefully check whether the specifications (dimensions), materials, etc. of the products and spare parts supplied are consistent with the list? Is there any sign of damage?
All parts provided shall be stored in a dry room with the air humidity as constant as possible.
If stored outdoors, the pump unit and Flat noodles must be covered to form a waterproof barrier to protect them from water droplets, thus avoiding any contact with moisture.
Short-term or long-term storage
The storage time of gas-liquid booster pump unit and spare parts will affect its storage mode. If you don't know how long the spare parts will be stored, please be conservative.
Regardless of the storage period, correct procedures and good records are essential. Environmental control shall at least include temperature, humidity, air pollution and vibration reduction.
Spare bearings not installed shall be kept in the original equipment manufacturer's packaging and stored horizontally. The storage time of sealed (grease lubricated) bearings shall not exceed five years. Non-rolling bearings may have a series of storage problems of their own, so please consult the pump manufacturer.
The storage of old pump is different from that of new pump. The big problem with used pumps or parts is that it is usually necessary to completely remove the pumped product before starting the storage procedure. Many people ignore this step or take 50% action, but make the pump 100% unusable.
Is the used pump stored in a proper place or in the installation area? In most cases, it is necessary to remove the pumped product and spray or atomize the metal surface of the flow passage with anti-corrosion oil. At the same time, coat all exposed machined surfaces.
The storage location and method of spare parts are one of the important factors to be considered. Ideally, the storage space should be indoor, and the temperature and humidity in it should be relatively constant (the humidity should be kept below 50%, and the temperature should be below 35 ℃). Temperature fluctuation shall be limited to below 10 ℃, especially in case of poor humidity control. Constant temperature and humidity are critical for successful storage because they reduce condensation that can lead to corrosion.
Some long-term storage procedures require the rotor to be placed in a sealed box, or the pump body to be sealed at the flange and penetration. Use a vacuum pump to extract air and then fill it with inert gas (usually nitrogen). Come to our website for more relevant content http://www.allarabandroid.com Ask!