There are many matters that need your attention when using and maintaining the gas booster pump. The following editor will give you a brief introduction.
Because the gas booster pump is driven by the compressor air source (2-8bar), generally the compressed air will produce a small amount of moisture, which will cause damage to the reversing valve on the pump, so the gas booster pump must be equipped with a filter and an oil mist, which is what we usually call a triplet. However, it is also necessary to ensure that the driving gas source is free of impurities and other particles. Turbine oil such as vg32 should be added inside the oil mist to lubricate and drive the cylinder block and reversing valve. Other oil will accelerate the internal aging of the sealing ring.
The temperature borne by the conventional gas booster pump is -22-85 ℃. If the temperature is too high, it can be started up and used only after cooling. The high-temperature pump needs to be used according to the instructions.
The gas booster pump is easy to maintain and needs to be tested. The interfaces of the pump are tightly sealed and installed in place. During maintenance, it is necessary to turn off the driving air source, then adjust the triplet air pressure to rise slowly, and judge after observing the change of the rising pressure of the pump. The output pressure can be adjusted according to the driving air pressure.
A filter is installed at the in (inlet) pressure of the pressurized part of the gas booster pump to ensure the cleanness of the pressurized gas medium and play the role of secondary protection. In addition, if the pressure at the high-pressure outlet is too high, it is proposed to install safety protection measures such as bursting discs. If the high-pressure outlet needs to be equipped with a buffer tank, be sure to buy a pressure vessel with a pressure bearing value higher than the rated output pressure of the pump body (with a pressure vessel certificate).
When the gas booster pump is maintained again, it must be maintained without air pressure. Turn off the drive, turn off the inlet pressure, and unload the high-pressure output pressure before maintenance. In addition, it is recommended to communicate with technicians or carry out maintenance under video guidance.
Self maintenance and pressurization can only be carried out after communicating with the manufacturer, or it can be handled according to the manufacturer's suggestions. Pay attention to us http://www.allarabandroid.com Consult immediately.