How to operate the gas-liquid booster pump after it is put into use? The operator should first put the equipment into use and load the gas-liquid booster pump according to the equipment instructions. What else should he do next?
After a period of operation, check the liquid in the oil tank: whether bubbles or foam are formed on the liquid surface? Is the oil level in the oil tank lower than the specified value of the oil level indicator?
Pay attention to the change of noise during operation. As the working medium is heated, slight noise enhancement is normal. The obvious noise enhancement or transient impact noise change may be due to the inhalation of air. When the oil suction pipe is too short or the filling height of the working medium is too low, air may also be sucked in through the vortex.
Avoid running the gas-liquid booster pump under full load (high pressure, large flow) for a long time.
The gas-liquid booster pump driven by the engine (such as engineering machinery) shall not run at high speed or low speed for a long time.
When starting at low speed, there is a limit to the high viscosity of the oil, otherwise the gas-liquid booster pump cannot suck oil.
The gas-liquid booster pump can only operate under the allowable data (such as large working pressure), and can only operate in good condition.
When doing any work on the gas-liquid booster pump, the equipment must be connected to the pressure free state.
The above is the relevant answer to the question "How to operate the gas-liquid booster pump after it is put into use". If you have any doubt or need, please come to our website http://www.allarabandroid.com Consult!